AssignmentInterfacing a Transducer to an Analog-to-Digital Converter and Interfacing Digital-to-Analog Converters to LoadsWatch video Week 5 – Op Amp DAC Circuit (Right click, save as)Design an 8-Bit DAC Circuit – Calculate the values for all resistorsInclude calculations and schematic in a Word document entitled: ‘HW5_StudentID, with your student id substituted in the file name. Show all work for full credit.Upload file ‘HW5_StudentIDComplete circuit in multisim!LabInterfacing a Transducer to an Analog-to-Digital Converter and Interfacing Digital-to-Analog Converters to LoadsThe purpose of this lab is to allow students to gain experience constructing Digital to Analog Converters in Multisim. Students will extend the concepts learned in the module and homework to build an 8-Bit DAC. Several binary inputs and the associated analog output values measured with a virtual digital multimeter will be captured in screenshots.Watch the video Week 5 – Op Amp DAC CircuitDetermine the values of all the remaining seven resistors and fill in the table 1.Table1:ResistorsValuesR11k ¦R2R3R4R5R6R7R8Recall the binary to decimal conversion and fill the table below:BitsBinary InputDecimal conversionMSB(S1)1000 0000S2S3S4S5S6S7LSB(S8)0000 0001Construct an 8-bit binary weighted DAC in Multisim and measure the output voltage Vout using the multimeter and record the computed gain below.Table2:BitsBinary InputVinRn(n = 1,2,3,4,5,6,7,8)RFOutput Voltage (Vout)Voltage Gain (Av)MSB(S1)1000 0000S2S3S4S5S6S7LSB(S8)0000 0001Take the screenshots of Vout measurements for the input/output combination for each of the above 8-bits.Answer the following questions:Determine the approximate value of RF which results in accurate digital to analog conversion.Write the expression for Vout in terms of Vin, RF and R for each bit. Also, express Vout in terms of all 8 input voltages.Starting from the least significant bit to the most significant bit, what is the effect of feedback resistance on the output voltage?From your measurements, does increase in the digital value result in increase in analog value? Please explain.Is the voltage gain of the op Amp different for each bit? Please explain why?Create a new word document called ‘Lab5_StudentID.docx’ with your GID substituted into the file name.Verify all calculations from analysis and measurements from simulations. Save the results along with the table and paste the screen captures in the word document. Make sure to answer the questions.Upload file ‘Lab5_StudentID’ in Blackboard.
Recent Comments